How To Fix A Sagging Door That Wont Latch

In order to get the bottom part of that door up a little take a look at the top and in my case as pictured below left side hinge. Inspect the hole of the strike plate for obstructions that may prevent the latch from engaging. Tighten the hinges first.

how to fix a sagging door that won't latch

Fix A Sagging Door

Door Won T Close How To Fix A Door That Won T Close The Family

Fixing A Door Latch Video Youtube

Unscrew the hinge screws and set them aside.

How to fix a sagging door that wont latch.

Diy staff what youll need.
Lift the door out of position just a few inches to give you room.
Look very closely and see how much space is between the door and the jamb.
To get the latch to work properly you may have to take the door down and repair the damage.

Step 1 check hinges.
If not do the lipstick test photo 1.
If you find that the latch contacts the strike plate too high or too low make sure all the doors hinge screws are tight.
If the door still wont latch check that the screws in the strike plate on the door jamb are tight.

A helper is a bonus here or you can place an old book under the door to support it while the hinge is off.
When a door latch wont catch its because the latch doesnt align with the hole in the strike plate.
Now place your cardboard piece on top of the screw holes in the jamb.
Remove the screws securing the hinge side of the storm door frame to the outside of the house with a phillips head screwdriver.

Fortunately there are several ways to fix a door that will not latch.
Go outside and close the storm door.
If the door is sagging and will not line up with the latch check the door hinges.
Shimming to the rescue.

Fixing a door that wont latch by.
How to fix a door that wont latch.
Sometimes you can clearly see the misalignment.
Next on the door check that the screws to the latch plate are tight.

Remove the screws securing the hinge side of the storm door frame on the inside door jamb if the hinge screws are in place.
1 adjust the door stop if it is angled with respect to the edge of the door.
Lift the door up to relieve the pressure on the hinges and tighten the screws.
Both of my hinges were secure but my door was still sagging and not latching correctly.

Press the latch in and let it out.

Home Ideas Tips Wooden Gate Repair In Coral Gables Fl