How To Frame A Bathroom Mirror

I used tape to hold it in place while it dried. In this diy tutorial jon provides step by. Paint front sides and edges of trim.

how to frame a bathroom mirror

Framed Bathroom Mirrors Wooden Framed Bathroom Mirror Wood Frame

How To Frame A Builder Grade Bathroom Mirror All About House Design

Mirror Frames For Mirrors Mirrormate Frames

Diy experts show how to make a wood frame for a bathroom mirror.

How to frame a bathroom mirror.

How to build a frame around a bathroom mirror.
Heres one of the corners dont be afraid if they dont match up perfectly.
Add latex paint extender to paint lengthening drying time.
You would subtract 4 inches times 2 to get the length of the board that will go between them.

The total length of each piece will be measured from tip to tip the long end of the miters.
How to frame a mirror step 1.
Put the liquid nails in the center of the molding.
If you use mirror caulk press the frame into place and use painters tape to secure until the adhesive can cure.

Customized frames give a clean look thats more permanent than a decorative mirror.
Using a miter saw cut each end at a 45 degree angle.
This will remove the remaining portion of the notch.
This should leave a 1 in overhang when installed on the mirror using painters tape to hold the corners together assemble the frame without glue on a flat surface.

Cut the top bottom and sides to those lengths on the outside edge with 45 degree miters on both ends.
Measure mirror and select frame style.
Get a caulking gun to apply your liquid nails.
Measure the mirror and add 2 inches to the length and width.

For example say your mirror is 64 long and you chose a 4 square block for the corners.
If using screws fill screw holes with spackling compound then sand and paint with another coat for a beautiful finish.
How to frame out that builder basic bathroom mirror for 20 or less apply your liquid nails or glue to the back of the board but make sure to leave an inch or so at the top of the board so you wont see the glue reflected in the mirror.
Make the blade height the rip width and the width the height.

Nothing that a bit of caulk cant fix.
To attach the frame to the mirror use mirror caulk or screws.
Also be generous with the amount of liquid nails you use.
Save yourself the hassle of trying to apply it without a gun or a 2nd trip to the store and make sure you pick one up.

Let dry two hours.
Next reverse the saw settings.
Frame your mirror that has plastic clips.