How To Install Quarter Round

Attach the quarter round trim to the base board and not to the actual laminate flooring. Continue to 13 of 13 below. Quarter round is available in.

how to install quarter round

Quarter Round Flooring Maydaymarch Info

Cutting Quarter Round Returns

Installing Baseboard Quarter Round Trim To A Laminate Floor Youtube

Put the tapered end of the nail set on the head of the nail.

How to install quarter round.

Cream colored pieces shown are quarter round.
When you join the pieces together you will get a square 90 degree angle that leaves minimal gaps on the wall.
Because its finish trim install quarter round with finish nails.
How to install quarter round molding.

Make 45 degree cuts on the ends of 2 different molding pieces.
The most common size is 34 inch.
Do not glue the wall side or floor side of the return piece.
If you are placing quarter round in front of the baseboard use any size you prefer or that will fill any gaps between the end of your new flooring and the wall.

The laminate flooring is designed to be a free floating floor as it could expand contract so you dont.
In step one weve cut two lengths of quarter round with two outside miters on each end away from the corner.
Installing the quarter round.
Press the return piece in place so the mitered edges meet and allow the pieces to sit undisturbed until the glue dries.

Make sure to cut this piece about 12 inches longer than it needs to be.
Attach the quarter round molding to the base of the baseboard.
Cut another length of molding that fits between the doorway opening and a piece of quarter round molding that you just installed.
Instead apply wood glue to the mitered edge of the return piece where it meets the first piece.

Use this type of cut to form corner joints wherever walls meet.
Unless youre installing a single piece of quarter round between two.
Floors are not always flat the good thing about 14 round is its flexible enough to follow the contour of the floor.
Hold the nail at a slight angle to the floor just above the bottom of the baseboard and tap lightly with a hammer until the head of the nail is just above the surface of the molding.

Installing quarter round in corners.
When nailing with a nail gun apply pressure to the 14 round at a 45 degree angle where the nail is going and push the 14 round down tight to the floor so the 14 round is tight to the floor when you pull the trigger.
Cut both pieces in opposite directions.
Drive a finish nail into the baseboard.

The cuts on the other ends intersecting with the corner will appear the same unless you choose to use the coping method.
This would match the top of the board perfectly.
When adding a piece of quarter round to the top of a piece of 1 inch trim use 34 inch quarter round.
How to apply quarter round trim attaching quarter round.

Cut quarter round pieces at a 45 degree angle to form joints.
Step 2 molding for the doorway wall.