How To Drill Out A Locking Gas Cap

The shear pins inside the lock will just snap off. The latch wont be broken but that screwdriver becomes your new gas cap key. The fuel cap i selected has a plastic top and this is where i chose to drill my hole.

how to drill out a locking gas cap

2019 Motorcycle Ignition Switch Key Fuel Gas Cap Tank Cover Kit For

Gas Tank Cap Auto Car Fuel Filler Oil Door Cover Black For Jeep

Fuel Filler Door Cover Gas Tank Cap For 07 17 Jeep Wrangler 2 4 Door

Aftermarket replacements that do lock are available from most car part stores.

How to drill out a locking gas cap.

There are many reasons you may have to replace your gas cap but the most common is a bad seal.
Drive an older vehicle with a gas cap and fuel door that dont lock.
These are probably easy enough to pick and remove the locking mechanism from the inside as well.
A flathead screwdriver the widest thatll fit in the keyhole a pipewrench for leverage and the cap will pop open no problem.

If you force it off you will mess up the fill on the tank but if you try drilling out the lock that could cause a spark and it could explode.
As the cap wears the seal will start to wear out as well.
It just takes a little practice.
A homemade lock pick and tension wrench can be made for pretty cheap.

Just know that if they have to drill the lock out small shards of metal can get into the gas and end up clogging the fuel filter.
Tip keep the spare gas cap key with the spare keys to your car.
Take it to a lock smith and have the cap removed buy a new cap or have a new keu made in the locksmith i was going to tell you to drill on the cap which workes but since its in the gas can it could create sparks and catch on fire.
Take it to a lock smith and pay him the take the cap off.

How to remove the locking gas cap on honda motorcycle remove or open the locking gas cap cover to reveal the key insertion slot.
Make sure to hold the cap with something such as a vise or clamp so that it doesnt try to run away from you while drilling and you accidentally put a hole somewhere other than where it is intended.
Make sure you select one thats.
Screwdrivers are better than drills in that they dont create heat or sparks.

Drill into the gas cap at an angle through the tumbler body where the.
If you are replacing your fuel cap anyway then you are already going to be spending almost as much as you would on a locking gas cap.
This will destroy the lock however.
Mark a spot just to the right of the key insertion slot on the bare metal of the locking gas cap.

You need a new fuel cap anyway.
This may not be legal to own in your locality.
If ya gonna drill it out buy a load of malleable mastic build a wall well around the key hole 1 or so high.